Step Two – Shake the Crep Protect Spray for a few seconds to make sure that the elements have all combined Now, before applying the spray to your footwear it’s important to clean the shoe. This doesn’t need to be a full deep clean, but you will need to remove any excess dirt that can be seen on the shoe. Using the Crep Protect Brush, gently brush along the upper of the shoe in a circular motion moving towards the midsole. Repeat this step a few times to ensure that no dirt has been left on the shoe before you start the spray application. Once you have left the sneakers to dry for 10 minutes, you can begin to apply the second coat of Crep Protect Spray. Following the same process that we outlined in Step Three, press down on the spray from 20cm away and start at the top of the laces, moving towards the toe box. After you have done this, turn the sneaker around and spray from the heel up towards the toe box again. Step Four – Let the spray set for 10 minutes, leaving them in direct sunlight or inside at room temperature Rizwan: “We wanted to recreate our category and that’s what we’ve done. We’ve got Premier League footballer Dele Alli and DJ Khaled promoting a shoe care brand. That would have been ludicrous to think about a few years ago. We have built a premium brand; the Apple of shoe care.”

Yes it can. We put the brush through years of research and development and came up with something that is safe to use on all shoe materials. Yes, take caution not to use excessive water and brush carefully. Note dyed suede can bleed, which means you should avoid getting them wet at all. We recommend always testing first in an inconspicuous area for this bleed. Step Six – Leave the shoe for a further 10 minutes in direct sunlight or inside at room temperature We have a 30-day return policy, which means you have 30 days after receiving your item to request a return. Following the same process as before, leave the sneaker to dry for 10 minutes in direct sunlight or in a room temperature room. After the shoe has been left to dry for 10 minutes, you will be able to put our Crep Protect Spray to the test.

THE ULTIMATE SNEAKER CREASE GUARDS

We’ll be showing you how to apply the Crep Protect Spray to the adidas Yeezy Boost 350 V2 “Tail Light”. As one of the latest Yeezy 350 V2s to release, we thought that this was a match made in heaven. Of course, this method applies for all footwear that you are applying the Crep Protect Spray too, whether it’s Jordans or Air Max. Without further delay, let’s take a look at how to use Crep Protect Spray. We ship globally from either one of our 3 hubs, which are based in the United Kingdom, Netherlands and USA. After your sneakers are all dried off and you’ve applied two coats, you can see the Crep Protect Spray in action. Our super-hydrophobic spray creates an invisible coating which repels liquids and repels stains. The nanotechnology ensures that water rolls off the fabric without affecting the material. The spray should last for approximately two weeks if you follow the steps correctly!

Step Three – Holding the Crep Protect Spray 20cm away from the shoe, begin applying the spray starting from the laces to the toe box. Then work your way around from the heel to the toe box again going around the sides of the shoe.